blittle Posted October 3, 2008 Share Posted October 3, 2008 Hi, I am new to Solidworks and am learning the basics. I am trying to design a simple part for a saxophone case. The main part is simply an extruded shape with filleted edges. The problem I have is with the bell curve which extrudes from the main part top and bottom. Is it possible to simply use a dome or similar extrusion teqnique to bulge the area specifically at the point of the bell or do I need to do a more complicated 3d drawing to achieve a cone shape on both sides. I have tried several different methods of achieving this but have not achieved anything yet that I am satified with. Thanks, Ben. Quote Link to comment Share on other sites More sharing options...
jkristia Posted October 3, 2008 Share Posted October 3, 2008 I would draw the profile and the do a revolve - or revolve cut to remove the part from you base shape Quote Link to comment Share on other sites More sharing options...
design-engine Posted October 27, 2008 Share Posted October 27, 2008 post a picture. The use of surfacing could be required. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.