kwortman
17th Oct 2008, 02:59 pm
I have a question about the display of haloed lines. I am using ABS2006.
I am using a 10” Dia Round duct slip joint US imperial duct at 12’ elevation.
I have a 24” x 24” square louver face ceiling diffuser-10” neck at 8’ elevation
I am connecting the two with a 10” Dia round corrugated flex duct slip joint US imperial flex duct at 12’ elevation.
The haloed lines show up correctly when the 24x24 diffuser in underneath the regular duct but the haloed lines only show up at the connector when the diffuser is underneath the flex duct. Are the haloed lines supposed to show up underneath flex duct or am I just beating my head against the wall.:?
I am using a 10” Dia Round duct slip joint US imperial duct at 12’ elevation.
I have a 24” x 24” square louver face ceiling diffuser-10” neck at 8’ elevation
I am connecting the two with a 10” Dia round corrugated flex duct slip joint US imperial flex duct at 12’ elevation.
The haloed lines show up correctly when the 24x24 diffuser in underneath the regular duct but the haloed lines only show up at the connector when the diffuser is underneath the flex duct. Are the haloed lines supposed to show up underneath flex duct or am I just beating my head against the wall.:?