MaroManRS305 Posted October 21, 2008 Posted October 21, 2008 Hello, when I use my object snap it tends to leave a "shadow", if you will, of the object snap after I navigate away from the object snap location. I do not necessarily have to select that point, it sometimes just appears and stays there until after I close AutoCAD. Any suggestions on how to fix this problem? Thanks. Quote
CmdrDuh Posted October 22, 2008 Posted October 22, 2008 define shadow a little better. If your talking about little plus + marks, then BLIPMODE might infact be the problem. If its a tiny mark that goes away after you click , it could be OTRACK is tracking the points you have touched via the osnaps. But if your talking about a SQUARE or TRIANGLE is being left on screen until you close, that sounds like a video card driver issue Quote
wannabe Posted October 23, 2008 Posted October 23, 2008 Try a regen straight afterward. That should let you know if its a graphics issue, hopefully. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.