allive88 Posted November 29, 2008 Posted November 29, 2008 Is there a way to assign "line width" to a 2D spiral? (It's actually a coned helix with zero thickness). I tried to explode the spiral, hoping it would be converted as a polyline so i could used the simple polyline edit command but it became a spline instead. Quote
CarlB Posted November 29, 2008 Posted November 29, 2008 Well from a spline you can convert to a polyline. Several ways have been discussed many times: -dxf to R12 -"flatten" with express tools -Use "spl2pl.vlx" free routine from Dotsoft -offset it a small amount; offset item will be a polyline. offset it back to original position Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.