Chrisseg Posted December 23, 2008 Posted December 23, 2008 Im trying to place a ceiling grid my ceiling is 16' high i can place it in the right spot but when i go to 3d its showing it on the floor is there something im not doing right i cant seem to get it elevated to 16' any help? Quote
ReMark Posted December 23, 2008 Posted December 23, 2008 Disclaimer: I do not use MEP 2009. Curious as to whether or not MEP 2009 has an "elevation" command? Quote
2kdesigner Posted December 23, 2008 Posted December 23, 2008 I don't use MEP so this may not help. I'm assuming you've drawn in Top view. Try going to Front View and then 3D orbit slightly to see your tile. Use a Move command and raise it 192" or whatever it takes to get it to your proper height. Quote
ReMark Posted December 23, 2008 Posted December 23, 2008 If you use the above advice (good) make sure your UCS is in the correct orientation. Don't want to be moving anything in the wrong direction. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.