Labeling Problem

[Astr8upfella]

Hey everyone. I'm using LDD Civil 2000i...I know...My boss is a tightwad and hasn't upgraded us yet. Anyway, I'm designing a storm sewer. I calculated the slopes myself and entered everything into the computer. I want a constant slope of 0.5%. Everything looks good on the table where you enter all your data into. Then I generate the profile and the slopes are 0.4, 0.37, 0.7...what gives. I can't figure it out. Any help would be great. Thanks.

[rustysilo]

If you go back into the table view are they still set to be 0.5%?

[Astr8upfella]

Thanks for the reply. Yes, that is the weird part. I go right back to the table and they all say 0.5%, but in the profile they're all different.

[rustysilo]

Are only the labels wrong or is the linework coming in at the other slopes as well?

I don't even have Land loaded anymore so I can't do much to help. You could try to run a new profile and see if the problem persists.