Enfiel3D
3rd Jan 2009, 12:57 am
Greetings!
I found that setting tolerance to upper of lower limit in parameters window does not affect the dimension used in sheet metal features (flange distance for instance). How can that be mended?
I found the way out of the problem by creating additional parameter that deducts from the needed distance (when not zero), but that is sort of a makeshift tolerance, not very good.
I found that setting tolerance to upper of lower limit in parameters window does not affect the dimension used in sheet metal features (flange distance for instance). How can that be mended?
I found the way out of the problem by creating additional parameter that deducts from the needed distance (when not zero), but that is sort of a makeshift tolerance, not very good.