Mark1965 Posted February 19, 2009 Posted February 19, 2009 Hi all Im stuck as i have a drawing that when i dimension shows 1.3 instead of 1300 and will not change no matter what i do, it says on the title block 1:50 so im not sure if it has been scaled in model sppace? but if i try to copy with base point somthing from another 1;1 draing it it huge in this one? Help please. How do i get it back to 1:1? Mark Quote
JBullseye74 Posted February 19, 2009 Posted February 19, 2009 If its not scale 1:1 you need to scale it down using Scale Reference. i.e if a line is 50mm and it should be 1mm you select SCALE then select base point then type R for Reference then type your 1st reference length which is 50 now your new reference length which is 1 then enter. Does this solve your problem? Quote
Mark1965 Posted February 19, 2009 Author Posted February 19, 2009 Hi thnx for quick reply when i try to copy a fitting from another dwg to this one it is huge, but if i scale it down to.0010 it seems to fit but im not sure how to scale the dwg up and it reads 1300mm as 1.3?. If i try to scale dwg up the the dims increase too Thnx Mark Quote
Mark1965 Posted February 19, 2009 Author Posted February 19, 2009 Thank you JB i had to select the whole dwg and change it to 1000 at scale from 1.000 and it now measures right:D :D Mark P.s I hate scale Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.