Cannot Access Display Drawing Status Bar

[tomg]

:wink: CURSOR COORDINATE VALUES! I CANNOT ACCESS THEM AS IN VIEW THEM. i GO TO TOOLS> OPTIONS> SHOW DISPLAY DRAWING STATUS, BUT IT WON'T TURN ON. ANNOTATIONS, SCALE TABS(BUTTONS) show but not everything I need. I really have spent way too much time on trying to repair this. I'm guessing I am going to get a reinstall suggestion. Anything other than that?

[darn-net]

To the very right of the status bar there should be a padlock with a drop down arrow. Click the arrow and Cursor Coordinate Values should show up on the list and I presume be unchecked.

I am assuming LT has the same status bar as the Full Version.

[tomg]

The only choices I have under that arrow are annotation scale,
annotation visibility & auto scale. This weekend auto cad got corrupted or something, and I did have the status bar BUT NO Tool bars.

[darn-net]

That drop down is for the drawing status bar. Are there any other drop down arrows on the status bars below the main screen. One should have more settings. Here's a snapshot of 2008 options (non LT sorry)
10491

[tomg]

Thank you Darn-net. I have only one alternative. Reload

[darn-net]

Are you experienced in Profiles and Workspaces? If so would try saving the your current profile. Then try to switch to or start with a fresh profile.
Also there may be an alternative using the registry to change this.

[tomg]

I will look into that tonight. Thank you Darn-It