Jump to content

iparts in assembly mode

FLASH

By FLASH
in Autodesk Inventor

 Share

Recommended Posts

FLASH Rookie

FLASH

Posted
Posted

can you create an ipart in assembly mode or do you have to create in part mode then place part into the assembly?

Rob123 Apprentice

Rob123

Posted
Posted

You can, but its easier to create one outside of the assembly (cause of all the Parameters):)

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...