cvriv.charles Posted March 22, 2009 Posted March 22, 2009 I made a tube. I want to bore out each end of the tube to whatever diameter and go .3125" deep. I did the top of the tube no problem. I created a circle at the end of the tube and used presspull to create the bore .3125" deep. Easy. The bottom of the tube for whatever reason just would not cooperate. I did the same procedure except this time instead of bore I created a solid within a solid. I had to use the subtract command to subtract that internal solid to create the bore. Why did it do that? I attached a dwg at the point where I just got done press pulling the bottom of the tube. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.