Point Level round-off

Hello, I am a bit confused now, it has never happened before.

I recently got a dwg file and when I try to export the elevation text to a text file using the txt2xyz vlx I get only the lvalue that is before the coma that seperates the decimal units. If I have a level of 142,37 i get a 142,000 in my text file.

Steps I take:

1. Appload the vlx

2. find and replace all the blank spaces that have been left after the coma in the text (142, 37 becomes 142,37).

Export them to a text file (tried both, selecting entities and layer)

a small sample from the text file:

30,705457.094,266235.432,141.000

31,705433.503,266230.614,141.000

32,705434.361,266232.574,142.000

33,705439.080,266434.880,140.000

34,705432.266,266433.469,140.000

35,705420.817,266431.231,138.000

36,705419.105,266432.570,138.000

37,705402.515,266430.144,136.000

38,705401.952,266427.666,136.000

39,705402.176,266426.118,137.000

40,705396.575,266424.798,136.000

Some points however show up correctly from the same drawing, but most of them don't

Plus the coordinate precision is supposed to be 4 digits after the seperator, where can I set this variable as well?

Thanks for all your time!

Aaarrgghhh, i figured it out, some of the hight text decimals were delimited by coma and some were delimited by a full stop (dot) ("," and ".") and the tx2xyz vlx file works only if there is a full stop (".") delimiter. I just got quite a messy topo plan

But still I would like to know where can i set the coordinate decimal precision?

Thank you!