The Nickster
20th May 2009, 03:27 pm
Hello all,
a co-worker of mine is having trouble with his autocad 2010 LT. He copied an exploded title block over to a new drawing, that title block had an object that was hatched solid in the drawing that he copied it from. (basically a company logo produced in AutoCAD)
When he pasted the object into the new drawing, the hatch did not show up, he tried tracing the outside lines of the object and creating a basic duplicate of the object and hatching that, but in either case the hatch will not show up. At the command prompt it does not say "valid hatch boundary not found."
Its like the hatch is being created but it cannot be seen. No layers are frozen or turned off either.... what am I over looking here? I've never ran into this kind of problem before and i don't like not being able to help when it's AutoCAD related..
Please Help!!!!
Thanks in advance.
-The Nickster
a co-worker of mine is having trouble with his autocad 2010 LT. He copied an exploded title block over to a new drawing, that title block had an object that was hatched solid in the drawing that he copied it from. (basically a company logo produced in AutoCAD)
When he pasted the object into the new drawing, the hatch did not show up, he tried tracing the outside lines of the object and creating a basic duplicate of the object and hatching that, but in either case the hatch will not show up. At the command prompt it does not say "valid hatch boundary not found."
Its like the hatch is being created but it cannot be seen. No layers are frozen or turned off either.... what am I over looking here? I've never ran into this kind of problem before and i don't like not being able to help when it's AutoCAD related..
Please Help!!!!
Thanks in advance.
-The Nickster