Quicker way to select edges when filleting?

I am using AutoCAD Architecture 2009.

Is there a way to select all edges of a face in one go when using the fillet command instead of selecting all edges individually as a chain? (like loop select in the chamfer command)

I hope "lisp" routing can do.

if you have sharp corners, no not that i know of. If all your corners are "blended" to each other when you select chain and make your second selection it should select them all. So say you had a cube and you performed a fillet on all the vertical edges first, when you select the top edge and and chain it will select the entire edge. I believe you can also perform a filled by selecting faces but im not sure if architecture has this.