Can't save my 2010 dwg!!

Ok this is really doing my head in.!! I'm working with 2010 and i'm working on a drawing i created on 2009 but it wont let me save it!

I keep getting this message!........

Tried a purge and a save as an earlier format but to no avail!

Then opened the same drawing in 2009 and it saved fine!!

Has anybody come accross this and know of a fix?

Regards

Take a look at: http://discussion.autodesk.com/forums/message.jspa?messageID=6021048

Thanks rkmcswain - wow i tried all of those fixes but no change! still the same

Have issued a Help Desk request with our subscription- will let you know the reply.

Hi Bullseye, we've had this problem since 2009. We just upgraded to 2010 and hoped the problem would go away but it is still here. I find it only does it on the second save, so I open a new drawing, save it, close it and then open it again and it is always fine from then on.

We've also done all the fixes and updates that autodesk has mentioned but still no fix. It does seem to be a network issue, at least all the posts I've read on different forams seem to all be when saving to a network.

Anyway, you are not alone. If you do find a fix please post it here and I will do the same.

Rachel

Response from Autodesk.

Twill be a fix in the next service pack!

Current fix: to WBLOCK your drawing out & into a new drawing same base point & using your design center to also copy in your layouts and activate viewports if required. Took about 10 mins to do but well worth the fix for now.

Cheers bwans

Thank you for the update JBullseye74. The information may prove useful to others.