View Full Version : Embossing Text
22nd Jun 2009, 03:27 am
I am trying to emboss text onto the surface of a tapered pipe but it keeps failing because the face is not tangent to the profile plane. Is there a way to do this?
22nd Jun 2009, 01:41 pm
You should state when you are not using the latest release as otherwise you might get a solution you cannot open.
Make the workplane tangent to the cone. Depending on design intent you might end up having to do each letter separately.
22nd Jun 2009, 10:38 pm
Powered by vBulletin™ Version 4.1.2 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.