Block with Attribute

In the attached drawing there is a block with an attribute. when i go into block editor i am unable to see the attribute e.g 62.600

any ideas on what is wrong?

cheers

level.dwg

After you type BEDIT at the command line, select instead of your block named CSAL01PL

when i do that i still cant edit the attribute.

Anyone else with 2008 care to have a look ?

Maybe this is one of the slight differences between 2008 and 2009 - as it seemed to select the attribute on my system.

doesn't work here - my guess is its an old block that has been updated and not attsynced.

Where did you get the block?

I've just opened it in LT2002 and can edit the attribute value OK using _attedit.

Or are you trying to change the attribute tag?

I've just opened it in LT2002 and can edit the attribute value OK using _attedit.

 

Or are you trying to change the attribute tag?

yeh i am trying to change the tag

Hi ankers,

Not sure if you have resoveld this. (Or maybe not understanding you correct.)

I opend your dwg and typed battman.

The command line said 'The selected block has no attributes'.

I copied your block and exploded and made a new block with attributes.

Inserted it and was then able to change the tag through the battman command.

Make sure in settings that 'Apply changes to existing references' is unchekced to stop the tag in the block/s already inserted being updated.

Insert the block again and the tag shows it changes.