Ploting to eps / dwg to eps

[Moe`]

I know that there is a way to plot to eps, I've done it in the past but my computer was swapped out not too long ago and this was just one of the o so many things i took for granted and now have to set up again. Where I'm running into problems is how to make that option available. I also know that there are converts for dwg to eps.

which route do you prefer when the end product is a eps file? Whats easiest and fastest


Currently using 09 LT

[dbroada]

I would configure a new postscript printer and just print to that

[Darin.Green]

I know that there is a way to plot to eps, I've done it in the past but my computer was swapped out not too long ago and this was just one of the o so many things i took for granted and now have to set up again. Where I'm running into problems is how to make that option available. I also know that there are converts for dwg to eps.

which route do you prefer when the end product is a eps file? Whats easiest and fastest


Currently using 09 LT


Go to the layout you want to plot. Type "Export" and change the file type to .eps...