Arc length modify

Hi All,

a pleasant day to you all, i have some question regarding to an arc i have 635.46 arc length i need to modify it to 400.00 but i dont know how i try to check in properties but the arc length is locked and could'nt modify at all, any suddgestion how to modify it:oops:

advance thanks to all,

I dont belive it possible to edit an arcs length by using the properties. I would either stretch it equal amount each end (to keep the height of the arc) or redraw it.

or always do a scale with reference of 635.46 then the new value of 400.00 but that will change the height of it unless you do various measurement then restore the hight to what it was previously.

Use the Lengthen command (Total option)

"lengthen" should work?!?!

I know is closer from Pittsburgh to England:D:D:D

Thanks mates,

i just treid your suddgestions i think lengthen is my first option, the total length for 400.00 work fine only its not defined what will be the 2 ends of arc will be reduced. But this will help me a lot

Many thanks,

Only changes will be made to end you selected: it will be extended

You need to be sure which end need to be modify