Pipe connection question

[cadgal]

Hello
I am modifying some pipes, and I have come to a place where I need join two pipes with an elbow, but I can't figure out how!

I'm run into this before and ususally end up just faking it,but there has to be a way.

I have attached a picture of what I"m talking about.

http://img.photobucket.com/albums/v506/vanilla_girl/pipequestion.jpg


they are at the same elevation, there has to be a way to do this.

thanks!

[Ritch7]

you use a library of parts?...
or In vault etc?..

[cadgal]

Well, I guess I just use the library that came with MEP, not sure what in vault is, so I probably don't use it lol

[StykFacE]

Back one of the pipe's off a few inches, or even a few feet if needed. Then run the other pipe right into the end of the moved one, and they will connect.

[OSCGOLF]

My guess is you'll need to add the "elbow" part to you pipe sequence...
it looks like you have an elbow up and to the right... correct?

[xincao]

Click one of the pipe's plus grip and snap to another one, that will be connected.

-Justin
Product Designer of AutoCAD MEP