Jump to content

Cogo Ponts (hundreds and thousands place)

kc27315

By kc27315
in AutoCAD Drawing Management & Output

 Share

Recommended Posts

kc27315 Contributor

kc27315

Posted
Posted

Using Civil 3D 2010, I have some cogo points where the text reads "4520.23 TA", etc. I want them to read "20.23 TA" without having to lower the corresponding surface by 4500 feet. Any suggestions. Thanks.

kc27315 Contributor

kc27315

Posted
  • Author
Posted

Figured it out -- using "Expressions" and then suubtracting 4500 from the "point elevation". Thanks.

 

Is there a way along with this that I can mark this thread as "Solved"?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...