MikeS Posted August 30, 2009 Posted August 30, 2009 When I try to replace a block - either thru Design Center (Redefine only) or with Blockreplace, the block does not update (even with multiple Regens) until I open the block in Block Editor. After opening and saving the block in Block Editor, all instances of that block update correctly. Any ideas on how to get the blocks to update without editing? Thanks. Quote
MikeS Posted August 30, 2009 Author Posted August 30, 2009 OK - I discovered most of the problem. The block changes (between the replaced block, and the block to be replaced) were all in Attributes, so ATTSYNC updated the attributes. The only issue now is that I have updated attribute definitions in multiple blocks. Is there any way to ATTSYNC all block names in the drawing at once? Thanks. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.