keighleyboy Posted September 24, 2009 Posted September 24, 2009 On one drawing only, the pickbox and cross hairs are jerking around the screen as though SNAP was on. But I have set SNAP to OFF. What has happened? Quote
JoeC Posted September 24, 2009 Posted September 24, 2009 Did you get the drawing from a third party? If so, try copying and pasting into a "fresh" drawing. I often have the same issues with customer drawings that were made in a different version or a vertical product. This usually works for me. Quote
rkmcswain Posted September 25, 2009 Posted September 25, 2009 Turn off Snap Mode (F9) The OP already said it was off. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.