christreeroot Posted October 6, 2009 Posted October 6, 2009 When trying to copy and paste or cut and paste , nothing happens and i get the following in the command box..... Command: _pasteclip Duplicate definition of block _ArchiTick ignored. Any Suggestions ? Thanks In advance Quote
ReMark Posted October 6, 2009 Posted October 6, 2009 Are you current with all updates to Civil 3D 2009? When did the problem first occur? What is the original source of the drawing you were working on when the problem occurred? Quote
christreeroot Posted October 6, 2009 Author Posted October 6, 2009 Are you current with all updates to Civil 3D 2009? When did the problem first occur? What is the original source of the drawing you were working on when the problem occurred? Yep i am current with updates etc, i have just opened the drawing this morning started drawing all my areas on and when i go to c/paste the above happens, it wont even copy into a fresh sheet and when saved and reopened most of the data including the origonal is gone..... Regards Quote
christreeroot Posted October 6, 2009 Author Posted October 6, 2009 Further developments..... When i try to open the drawing most of the data has now gone, however when you look at the desktop pic the data is there.... I am getting very confused now Quote
ReMark Posted October 6, 2009 Posted October 6, 2009 What are the specs for your computer? Are you on a network? Are Xrefs being used? Civil 3D 2007 had cut/paste problems which AutoDesk issued a hotfix for but I saw nothing listed for 2009. Quote
Dipali Posted October 6, 2009 Posted October 6, 2009 try to open the drawing thru recovery manager Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.