Robofreak Posted October 10, 2009 Posted October 10, 2009 I just had a quick thought about this and wondered if it was possible in Inventor Studio. Can you apply gravity that parts are subject to like say I had a rod on the top of a box that rolled off of the box. Is it possible to have the rod fall to the ground on its own with realistic movements like having tilt toward the heavier end of the rod ect... I know 3ds max can do it (I have this) but I have never used 3ds max before and I don't know where to start! Quote
shift1313 Posted October 11, 2009 Posted October 11, 2009 Yes you can in the Dynamic Simulation Environment. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.