View Full Version : Revcloud w/o the Bulges
Tomitalent
28th Oct 2009, 07:35 pm
I would like to draw a pline using the same technique that the revcloud command uses. What I am doing is tracing contour lines on a topo map raster image. The continuous clicking gets major tedious. Presently I am using revcloud and them decurving the line using pedit. I have looked at revcloud.lisp and quite figure out how the vetex are automatically added as you move the cursor.
lpseifert
28th Oct 2009, 07:43 pm
Not highly recommended, but you could try the Sketch command. Be sure to set Skpoly=1 first.
Tomitalent
28th Oct 2009, 11:02 pm
Thanks! That is exactly what I was looking for. All these years of engineering drafting and didn't know I could doodle too.
ReMark
28th Oct 2009, 11:44 pm
As I recall if you set the sketch increment to too low a level it was possible to crash one's computer. Of course that was back when dinosaurs ran amok. Just a note of caution if your system specs are less than adequate.
Powered by vBulletin™ Version 4.1.2 Copyright © 2012 vBulletin Solutions, Inc. All rights reserved.