paulf Posted December 21, 2009 Posted December 21, 2009 New one on me this and not sure how to resolve it, so any help would be appreciated. When I go to draw a line by inputting say, @1000 Also, when I rotate, its rotating the objects clockwise, not anti-clockwise. Any one got any ideas? its only happening on one of my drawings, if I open another drawing or start another, its normal and the use is set to world, so I cant see how it can be the UCS? Quote
ReMark Posted December 21, 2009 Posted December 21, 2009 Sounds like you got a drawing from an outside source where someone used the Units command to change both the Angle and the Direction of the line. Quote
viviancarvalho Posted December 22, 2009 Posted December 22, 2009 Paulf I think setting the ucs to world should solve your problem. Would be better if you can attach the dwg. Quote
paulf Posted December 22, 2009 Author Posted December 22, 2009 The UCS is set to world and the drawing was an old one I saved as new, so shouldnt be a problem, will attatch the drawing from home tonight, I cant do it at work Quote
ReMark Posted December 22, 2009 Posted December 22, 2009 Did you take a look at the settings in Units at all? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.