True Axon View?

I need to make a 45/45 degree axon to show a plan and section with measurable integrity. So far the isometrics views cannot produce these drawings. If you could, please provide a way to achieve this view.

I need to make a 45/45 degree axon to show a plan and section with measurable integrity. So far the isometrics views cannot produce these drawings. If you could, please provide a way to achieve this view.

If drawing 2D you simply draw them the same way one would on the board.

If drawing 3D, it isn't going to happen. You may simulate the view you are after using the freeorbit command and rotating the view.

Just to clarify, Axonometric projection includes Isometrics, Dimetric, and Trimetric. Not sure what you want or mean by "45/45 degree axon".

I was trying to generate the drawing with a flatshot of a 3d model. I mean that the axon was to be seen as if the plan had been rotated 45 degrees then projected down.