Jump to content

idw to dxf R14 using inventor 2010 problems...

juskojj

By juskojj
in Autodesk Inventor

 Share

Recommended Posts

juskojj Newbie

juskojj

Posted
Posted

everytime i do a save as dxf R14 from my idw and open the dxf in autocad and zoom as far as i can on one of the intersections the lines are not connected but a gap there. This does not happen when I change it to a R2000. help?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...