how to plot tabs?

I was told to open a drawing and plot both tabs? I don't see any tabs. Darn stuck already!!

Thanks if you can help me.

Reika

Both tabs as in Model space and Layout 1 or Layout 1 and Layout 2?

Look at the bottom of your screen above the command line.

Ok I asked and was told two layouts. I don't see a tabs thingy showing anywhere.

Thanks,

Reika

If you do not have the Model space and Layout tabs displayed at the bottom of your screen at all go to Tools > Options > the Display tab and look under the heading Layout elements in the lower left-hand corner of the window. There should be a checkbox with the label Display Layout and Model Tabs. Put a check in it then click on the OK button.

2011? Click the arrow next to the big red "A" in the upper left-hand corner of your screen (the Menu Browser as AutoDesk calls it). In the window that appears go to the lower right-hand corner and click on the Options button. Follow the rest of the instructions I just gave you.

Got it! Thank you, thank you, thank you! Wow free help!

You're welcomed, you're welcomed, you're welcomed.

Who said anything about free?

That's gonna cost you the next round of beers!

You're welcomed, you're welcomed, you're welcomed.

 

Who said anything about free?

 

That's gonna cost you the next round of beers!

Rootbeer is all I can buy, never tried the real stuff, honest:wink:

Yep, sure, I know the drill. That's your story and you're stickin' to it.:wink: Gotcha. OK, everyone...belly up to the rootbeer bar. Reika's buying!