SadisticIron Posted April 22, 2010 Posted April 22, 2010 Back at this again. I am inserting an image and I can view it after insertion of the image. Now what I want to do is make polylines and arcs out of my image that I have inserted, but I am unable to even make changes to these images. Is there a software that will be easier to save my images into first and then insert them. All my images are jpeg and I have no luck. I have had people tell me about different conversion programs but that all cost a lot of cash flow. Any information will be very helpful. Thanks guys:D Quote
MikeScott Posted April 23, 2010 Posted April 23, 2010 WINTOPO is freeware and will do the trick.. it'll transform the raster image into vector format and allow you to save it as a DXF which you can then import into AuotCAD. Otherwise.. redraw the image by tracing it. Quote
SadisticIron Posted April 23, 2010 Author Posted April 23, 2010 Thank you Mike I will give this a shot. Quote
CADformat Posted April 23, 2010 Posted April 23, 2010 Hi Vectormagic will do the same,but I am not sure It is free Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.