Missing arc grips

When I draw an arc in my drawing no grips show up. This only happens when I draw one between 2 circles, using object snap. If I draw an arc just in the middle of nowhere, the grips are there.

I am working close to 0,0, I have run audit, restarted AutoCAD and increased the grip object limit. None of them have fixed the problem.

Any thoughts on why this is happening?

Thanks!

Seems to be a graphics issue, make sure you have updated your video drivers. That's the best you can do...

Btw, are you working in 3dwireframe SHAdemode? If yes, then switch back to 2Dwireframe and check if this problem continues...