AFitchguy07 Posted May 20, 2010 Posted May 20, 2010 How can I setup autocad to NOT open a new drawing on each launch? I did not see any related options under the open tab inside of options. Quote
AFitchguy07 Posted May 20, 2010 Author Posted May 20, 2010 Check this thread. Regards, i checked it out but it was back from 2007. i think a few of the file names have changed.. i posted reply in that thread. you might know the answer if you want to wiggle over there and check it out. thanks again. Quote
MSasu Posted May 20, 2010 Posted May 20, 2010 AutoCAD is compatible with his previous releases, so all old features/behaviors are preserved (even if some are accessible only by code). So, you may use that solution with confidence. Regards, Quote
WCCSAM Posted May 20, 2010 Posted May 20, 2010 Type Startup in the command line and set the value to 1 Then next time you start Autocad it will bring up the Startup box instead of open a new dwg. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.