rbdesign
7th Jun 2010, 06:23 pm
Am haveing a problem with my zoom window command in ADT 2006
I get this responce every time I try to zoom/window
Command: w ZOOM
Specify corner of window, enter a scale factor (nX or nXP), or
[All/Center/Dynamic/Extents/Previous/Scale/Window/Object] <real time>: W
Specify first corner: nil
Specify first corner: Specify opposite corner: *Invalid*
I think this is a simple command fix but am not sure. I had a failure and had to load into a new computer with xp home. I am also using a SummaSketch III 12x12 tablet with tabletworks from calcomp Ver10.08
I get this responce every time I try to zoom/window
Command: w ZOOM
Specify corner of window, enter a scale factor (nX or nXP), or
[All/Center/Dynamic/Extents/Previous/Scale/Window/Object] <real time>: W
Specify first corner: nil
Specify first corner: Specify opposite corner: *Invalid*
I think this is a simple command fix but am not sure. I had a failure and had to load into a new computer with xp home. I am also using a SummaSketch III 12x12 tablet with tabletworks from calcomp Ver10.08