Jump to content

AutoCadLT2011 - Joining two pipe profiles

ggodwin

By ggodwin
in AutoCAD General

 Share

Recommended Posts

ggodwin Contributor

ggodwin

Posted
Posted

I have AutoCadLt2011 for some customer bicycle design. Now, I am at the point of cutting the tubing and welding the bike up.

 

It would make my job much easier if there were a way to create a pipe cutting template I can draw on the pipe ends.

 

is there anything in AutoCadLt2011 to do this?

ReMark Grand Master

ReMark

Posted
Posted

Nothing that I'm aware of. It would be nice if you could generate a pattern of sorts but that is beyond LT.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...