MID BETWEEN 2 POINTS- How do you say this in lisp?

Hi Guys, just a simple question because I'm trying to create a shortcut command for my multiline command. I know about END, PER, MID, INS, CEN, but what about mid-2pt, how should I write it?

Thanks!

You may mean this mtp or m2p .

Regards.

Tharwat

thanks! thanks! have to repeat the words haha forum doesn't accept less than 10 letters. I'm posting another question, hope you can visit this link.

http://www.cadtutor.net/forum/showthread.php?52048-Expand-Squeeze-or-quot-modified-quot-multi-Stretch-command-is-there-any

have to repeat the words haha forum doesn't accept less than 10 letters.

I do not know what do you mean by that.

But the two examples that I gave you are having the same meaning.

Tharwat

I do not know what do you mean by that.

 

But the two examples that I gave you are having the same meaning.

 

Tharwat

Hi Tharwat- I'm sorry if I confused you. Don't worry it's no big deal. What I meant above is the word "thanks!" in my reply.. word "thanks!" alone was not accepted by the forum since it should be more than 10 letters so I have to rephrase it. By the way, I posted another question, kindly check it out also if you are free. Cheers!

http://www.cadtutor.net/forum/showthread.php?52048-Expand-Squeeze-or-quot-modified-quot-multi-Stretch-command-is-there-any

Now it is clear .

About the link I can see it in the new posts .

Regards.