Osnaps changing based on command input

I've searched everywhere and can't seem to find an answer for this. My Osnaps are changing based on the command I input.

Line = End, Mid, Cen, Int

Circle = End, Cen, Int

Polyline = End, Int

Spline = End, Nearest

Rotate = End, Cen, Int

etc, etc

Even when turned off they turn themselves on as soon as I enter the command.

Please tell me I'm missing something obvious as I'm starting to panic a bit!

System is Windows XP running Autocad Mechanical 2010, along with Toolpac 13.0 and CDGPurge

It's probably something that Toolpac is doing. Does it allow you to set specific osnaps depending on what tool you're using? I don't know how or why that would be useful, but that would be my first guess.

It's probably something that Toolpac is doing. Does it allow you to set specific osnaps depending on what tool you're using? I don't know how or why that would be useful, but that would be my first guess.

It does almost seem like a Toolpac feature, but I'm pretty sure it's not. I just tried removing it (Toolpac) and still have the same problem. I'm not used to working with Mechanical, is it possible that this is a Mechanical feature?

question...do you work for a company that has set up a "standard" for snap functions? If so, you may be suffering from some manager's idea of what you should use.

another question...is this a new phenomenon, or something that's been there from the start? If it's new, what has recently changed? Upgrades to software, hardware, or management can have unexpected results.

question...do you work for a company that has set up a "standard" for snap functions? If so' date=' you may be suffering from some manager's idea of what you should use.

 

another question...is this a new phenomenon, or something that's been there from the start? If it's new, what has recently changed? Upgrades to software, hardware, or management can have unexpected results.[/quote']

 

 

No, this is a new install, I am installing and using the program. I was previously using Autocad 2002. Nothing has changed software or hardware wise since the install.

Try "_.line" and see if it still does it.

Try "_.line" and see if it still does it.

Still the same, changes to End, Mid, Cent, Inter from just Endpoint. Is there any kind of an osnap file that could be repaired?

unless something fouled up in the install, and for the life of me i can't imagine what that would be, you should be able to set it them any way you want them, or turn them off completely. I'm not familiar with toolpac, so I don't know what that might have done to you. this is going to take some thought.