Undo

Is there a way to undo something in the middle of a command.

For example when I am using the trim command and I trim 5 things but the last one I accidently clicked the wrong area or line, can I undo only the last click. When I click undo it removes all 5 and I have to start from scratch.

Command: t TRIM

Current settings: Projection=UCS, Edge=Extend

Select cutting edges ...

Select objects or : 1 found

 

Select objects:

 

Select object to trim or shift-select to extend or

[Fence/Crossing/Project/Edge/eRase/Undo]:

Select object to trim or shift-select to extend or

[Fence/Crossing/Project/Edge/eRase/Undo]:

The Undo within the command will undo the last trimmed object

i just use ctrl+z

Instead of Undo hit u key on keyboard and Enter while still in the trim command. Repeat as needed.

Thanks, have to experiment with those commands more often too busy designing and not looking at commands.

Designerstuart that will undo all of the commands not just the last click.

Designerstuart that will undo all of the commands not just the last click.

not for me, i tried it.

Hmmm must be a setting you have because I just tried trimming two sets of lines, one at a time and it undid both.

Weird.

As JD Mather stated. You have to Undo or Ctrl+Z while still in the command. Once you terminate the command, Undo will undo the entire operation.

It was mid command. Ctrl+Z still undoes all clicks where as just using u will undo last click in command.