dunno wot to do now ..SHifT 1313

stuck on page 24 of your pdf.

and this is where i am at now..what am i actually trimming away...v.confusing.

Hey calibos, you want to remove the Blue section in my screenshot you posted. This will let you keep the purple section. Now the sketch in SW doesnt go past the surface which may or may not cause a problem in inventor, i cant remember. If so extend your spline so it goes to the edge or your surface.

Let me know if that works for you. Sorry ive had an issue with my inventor install and cant open it or i would be able to take a look at your file for you.

i think the problem i am facing is the create boundary part of the project(see pics). I dont know how this translates in AI 2010.

you can use a Loft in Inventor and it will be the same result. Boundary Surface in SW allows me to use Start/end curves and guide rails in any fashion. So one curve one guide(like a sweep but with 3d curves), or like a loft with a guide.

Shift can u send me this tutorial on email, or i can find it somewhere in Threads?

Regards,

Aleksandar

This tutorial is 4.39mb long ......in pdf format.

Much too long, than this forum will allow. you can pm# me with an e mail address, and i can send it you that way, if you wish...just how it was sent to me!!

Yours

Calibos

http://ola2.aacc.edu/tmcallinan/ENT280/Complex%20Surfacing-Speaker.pdf

that should work.

Great! Thanks!

Regards

Aleksandar