briton Posted June 1, 2011 Posted June 1, 2011 (edited) Whenever I stretch objects that have been hatched (from a drawing previously produced in AutoCad) the hatching either stays in the same position or goes haywire & spills out of the hatch area. What do I need to do to prevent this? Regards Briton Edited June 3, 2011 by Cad64 Advertising Link Removed Quote
ReMark Posted June 1, 2011 Posted June 1, 2011 Wouldn't the option "Associative" have to be checked off to prevent this? Quote
designerstuart Posted June 1, 2011 Posted June 1, 2011 are you sure your objects are drawn on a plane, i.e. if some points are not on Z=0 then the hatching can go a bit mad. Quote
ReMark Posted June 1, 2011 Posted June 1, 2011 A hatch pattern will sometimes spill out of an area due to a gap in the linework. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.