Attributes not following strech in dyn. block

Hi guys,

I have some trouble with one of my dyn. block.

2 Attributes won't follow the strech action.

The strech works with a lookup table.

Tried to attsync a lot. Removed all actions and started over. Made new attdefs aswell... i'm kinda out of ideas.

Could one of you check this out? Maybe i'm overlooking something.

Regards,

SB

dynbl.dwg

have you "locked" the attribute? It won't move UNLESS you lock it.

have you "locked" the attribute? It won't move UNLESS you lock it.

Locking the att doesn't help.

I can move them manually. But iff i i lock them i 'can't anymore.

SB

without locking them they will never move with a stretch. You will have to decide if you want it to move with a stretch or manually.

edit....

just tried it here and locking the attribute worked. I guess they have changed it on 2011.

Chaps... you need to highlight the attributes in your stretch and make them constant.

one more procedural note, lock you attribute and then add it to the strectch set

Chaps... you need to highlight the attributes in your stretch and make them constant.

Chaps... you need to highlight the attributes in your stretch and make them constant.

I don't get it...

They are part of the action selection set if that's what you mean.

And they can't be constant as i need to change them.

SB

Hey bud... sorry meant Lock

one more procedural note, lock you attribute and then add it to the strectch set

Nice one m8. It worked.

Thanks a lot