View Full Version : Tapering a hole?
22nd Sep 2011, 12:52 am
Not really sure how to approach this, but I want to make semi conical shaped hole that has a circle of 0.358 inches that tapers up to 0.457086614 inches in a length of 1.497 inches.
How can I do this?
22nd Sep 2011, 05:02 am
A Revolve Cut should work well here:
22nd Sep 2011, 08:27 am
Or you could use lofted cut... sketch your two profiles and then loft cut. Although revolve cut will probably be easier. There are usually many ways to do one thing in cad... :)
Powered by vBulletin™ Version 4.1.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.