Jump to content

Can't set the Hatch Pattern Scale prior to hatching

montypete

By montypete
in AutoCAD 2D Drafting, Object Properties & Interface

 Share

Recommended Posts

montypete Newbie

montypete

Posted
Posted

For some reason I can't change the hatch pattern scale prior to hatching an object although after placing the hatch I can. The procedure I am using is as follows in LT2011. Select hatch, set the hatch style, over type the scale say to 100, click inside the area to hatch. Immediately the hatch pattern scale sets itself back to 1 I then have to type 100 back in and then the hatching will be set. Does anybody have a cure? Many thanks.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...