bradk83 Posted October 20, 2011 Posted October 20, 2011 I'm new so please bare with me. At my job we draw half sections of forged parts. Car spindles, inner and outer races to bearings, etc... After everything is drawn to the machined profile I have to offset all surfaces to show forging stock. I have to offset anywhere from .85mm to 1.5mm per line/arc/etc. Is there a lisp that will offset all lines/arcs a certain distance at one time? Hopefully I have not confused everybody. Quote
Lee Mac Posted October 20, 2011 Posted October 20, 2011 Hi Brad, Welcome to CADTutor The difficulty with multiple selection for offset is determining to which side each object should be offset from a single point selection. Here is an example applied to only Line Enitities, but results would vary depending on the orientation of each line. Lee Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.