rdharvey Posted November 1, 2011 Posted November 1, 2011 Hi guys, When i am dimensioning a circle within the idw environment it is giving me the pull out dimension on one leader. How do i change it to the style of dim you would get if tou was dimming a length? it doesn't seem to be snapping to any points. I also have a barrel cam and i have been asked to produce a flat pattern sketch on the idw. Is this possible as its not a sheet metal part? find my part here : http://grabcad.com/library/barrel-cam Thanks in advance Rob Quote
rdharvey Posted November 1, 2011 Author Posted November 1, 2011 Ok sorted my dim issue out. Just the second point now... Quote
Bishop Posted November 1, 2011 Posted November 1, 2011 So far as I know, you'd have to either (a) convert it to a sheet metal part or (b) remake it as a sheet metal part. Quote
rdharvey Posted November 1, 2011 Author Posted November 1, 2011 hmm i tried converting it to a sheet metal part and making a rip but it didn't like it ... hmm Quote
JD Mather Posted November 1, 2011 Posted November 1, 2011 How big is the file if you - 1. Roll up the EOP 2. Right click on filename and select Send to Compressed (zipped) Folder? Quote
rdharvey Posted November 2, 2011 Author Posted November 2, 2011 How big is the file if you -1. Roll up the EOP 2. Right click on filename and select Send to Compressed (zipped) Folder? the file is 1.95 mb when the EOP marker is rolled up and zipped Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.