cogo lines from point to point

In the LDDT 2005 COGO line command, I used to be able to type ".p" and the prompt would ask which point to select (by number). Now when I type ".p" it says, "Point or option keyword required."

Any suggestions?

Are you currently using LDD 2005? or is that the version where the command was available?

Have you tried "-.p" yet? Sometimes by including the "-" the legacy commands can be utilized.

I am using LDD 2005. I tried the "-.p" with no success.

I moved this to the Civil 3D & LDD forum.

thanks much