lyngo Posted February 11, 2012 Posted February 11, 2012 Why is my hatch off set from what I want to hatch? Help? I pic the points of the area in 3d i want to hatch but it ends up hatching out of the points i select? Quote
ReMark Posted February 11, 2012 Posted February 11, 2012 3D? Then in all likelihood it probably has something to do with the origin point of your UCS not being properly located relative to the entity being hatched. Move it. Quote
ReMark Posted February 11, 2012 Posted February 11, 2012 There are any number of ways. You can do it manually via the command UCS or dynamically using the Dynamic UCS. How are you working in 3D to begin with if you have no knowledge on how to manipulate the UCS? Quote
lyngo Posted February 11, 2012 Author Posted February 11, 2012 Learning as much as I can. I think better in 3d. I just got to get over couple hurtals. Thanks for your help. but still a little confused. Quote
ReMark Posted February 11, 2012 Posted February 11, 2012 (edited) Using the Dynamic UCS by Ellen Finkelstein. http://www.ellenfinkelstein.com/acadblog/use-dynamic-ucs-to-speed-up-3d-drawing/ "You can use the Dynamic UCS to create objects on a planar face of a 3D solid without manually changing the UCS orientation." Edited February 11, 2012 by ReMark Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.