jgbgod Posted March 28, 2012 Posted March 28, 2012 When refering to the properties menue for an attached xref file, hw the HELL am i supposed to interpret ROTATION>Angle: E? Quote
Dadgad Posted March 28, 2012 Posted March 28, 2012 East. Whoever created the block had reset the rotation designation. I should assume that E would be zero degrees of rotation. Quote
jgbgod Posted March 28, 2012 Author Posted March 28, 2012 I just reset my UCS to global and the xref rotation angle is at approximately 70%%C Quote
jgbgod Posted March 28, 2012 Author Posted March 28, 2012 I'm good to go. Thanks for the reply. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.