NirantarVidyarthee Posted April 20, 2012 Share Posted April 20, 2012 When does a Hatch does NOT have area. I have a hatch, which when I select in Area command responds with 'Selected object does not have an area'. I have other hatches with same pattern that do not show this behavior. What could be the possible reason for this? Quote Link to comment Share on other sites More sharing options...
SLW210 Posted April 20, 2012 Share Posted April 20, 2012 Does properties show it as a hatch? Quote Link to comment Share on other sites More sharing options...
ReMark Posted April 20, 2012 Share Posted April 20, 2012 Sounds like a trick question. Post a sample drawing with this mysterious hatch (that has no area) in it. Someone here will take a look at it. Quote Link to comment Share on other sites More sharing options...
hugha Posted April 21, 2012 Share Posted April 21, 2012 Check that the hatch has a properly closed boundary. Quote Link to comment Share on other sites More sharing options...
NirantarVidyarthee Posted April 21, 2012 Author Share Posted April 21, 2012 Sample dwg attached NoAreaHatch.dwg Quote Link to comment Share on other sites More sharing options...
ReMark Posted April 21, 2012 Share Posted April 21, 2012 I believe answers have already been provided in your FIRST thread. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.