R4mP0 Posted June 22, 2006 Posted June 22, 2006 Hi everybody! Here's my problem (on v.2006). I generated a set of 3d points (a land survey) in a new drawing, then I copied them as a block into an existing drawing (a planimetry), rotating the whole group (only around z axis) to match the right orientation. I noticed that the point style maintains the original orientation (the UCS of the file where the points were generated). So, if I use a "+" style, this results a little bit rotated. Is it possible to modify the point style orientation so that it is aligned with the global UCS of my new file? Thanks! Quote
jeepmanblair Posted November 9, 2009 Posted November 9, 2009 I think the original poster worded it quite well....so BUMP!!! I don't see any way of rotating a point in the properties at all. I've got series of points that will come from different sources and will be rotated in different angles. Any help would be great. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.